HTH HTH SHOCK™
Extra fine granules
THE INSTANT SOLUTION TO CURE GREEN OR CLOUDY WATER AND RAISE THE CHLORINE LEVEL.
HTH Shock is the most concentrated hypochlorite available on the market. It is a fast-dissolving ultra-fine granules that dissolves much more quickly than the ordinary granules.
It is completely free of cyanuric acid (stabiliser), with no risk of over-stabilisation so no need to empty or renew the water during the season.
Characteristics
- Fastest and most effective shock chlorination on the market
- Minimum chlorine level of 75%
- Calcium hypochlorite (non-stabilised chlorine)
- For all types of pools
- Quickly increases chlorine content
- Destroys viruses and bacteries in the water
- Corrects green or cloudy water
Practical:
Handy packaging with handle and measuring cap
Dosage
500 g for 100 m³ of water per day
USE BIOCIDAL PRODUCTS WITH CAUTION. BEFORE USING, READ THE LABEL AND THE INFORMATION ABOUT THE PRODUCT.
INSTRUCTIONS FOR PREPARING CHLORINE SOLUTIONS
If the concentrated chlorine solution is prepared manually, the following procedure must be strictly followed:
- Always use a clean preparation container that should only be used to prepare chlorine solutions.
- Calculate the amounts of water and calcium hypochlorite needed to achieve the desired chlorine concentration (see the table below).
- Add at least 90% of the required amount of water (see table below) to the container.
- Slowly add the required amount of calcium hypochlorite to the water while agitating the solution.
- Add the remainder of the required water to bring the total volume to the desired level.
- Continue agitating for at least 15 minutes to ensure that the product is completely dissolved.
COMMERCIAL POOLS AND SPAS
- Do not allow anyone to enter the pool if the concentration of available chlorine is above the national limits, or in the absence of this, 3 mg/l for swimming pools and 4 mg/l for spas.
- For perfectly balanced water, maintain alkalinity (T.A.C.) at a level between 60 and 120 mg/l.
- In an open-air pool, maintain stabiliser concentration between 25 and 50 mg/l.
- Check the chlorine level in pools regularly because UV rays can partially degrade the chlorine.
- Adjust the pH between 7.0 and 7.4.
- Check that the filter is in operation.
- Permanent chlorination:
- Check that the preparation tank and the pump do not contain any stabilised chlorine (trichloroisocyanuric acid or sodium dichloroisocyanuratee: check the labels).
- Prepare chlorine solutions following the dosing table and instructions.
- Adjust the injection to maintain a level of chlorine that meets local regulations. In the absence of regulatory obligations, it is recommended to maintain a level of active chlorine between 1 and 3 mg/l for a pool and between 2.5 and 4 mg/l for a spa.
- Shock chlorination when opening the pool and if the water is green/cloudy: Adjust the injection rate to reach a concentration of available chlorine equal to 10 mg/l.
N° UFI
UFI:FRVN-8QU9-9A4P-MQTG
Certification
BAuA Reg.-Nr: N-76433; BAG Reg.-Nr: CHZN4084; PCS 99727
Caution!
Never pour water onto this product as it may react violently if it enters into contact with small volumes of water.
Application of this product is only authorised in pools that are connected to a waste water treatment plant.
Store in a dry place away from direct sunlight in a well-ventilated area, at an average daily temperature that does not exceed 30°C.
The expiry date and the batch number appear on the packaging.
Decanting must be avoided.
Never pour unused product onto the ground, into bodies of water or into pipes (sinks, toilets…) or drains.
Dispose of unused product, its packaging and any other waste in compliance with local regulations.
Use the tool (scoop or similar) provided. Do not store the tool inside the packaging.
The treatment must be carried out in the absence of bathers for shock treatment and until the product is completely dissolved for direct application as maintenance treatment.
This product should never come into contact or be mixed with any other preparation, wherever this may be (bucket, feeder, skimmer, tank, etc.).
Risk mitigation measures
W przypadku uzdatniania szokowego zabieg należy przeprowadzać, kiedy żadne osoby nie kąpią się, aż do całkowitego rozpuszczenia produktu przeznaczonego do bezpośredniego stosowania w ramach zabiegów konserwacyjnych. Stosowanie tego produktu jest dozwolone tylko w basenach podłączonych do oczyszczalni ścieków.
Ingredients contributing to the classification of the product
calcium hypochlorite ; CALCIUM HYDROXIDE ;
Biocidal product:
Product-type 2: Disinfectants and algaecides not intended for direct application to humans or animals. PT2
Users: Professional
SP – Water soluble powder
Active substance:
