HTH GRANULAR
Granules
10 kg
GRANULES TO RAPIDLY INCREASE THE CHLORINE LEVEL
Choc disinfection, fights green and cloudy water.
Continuous chlorination for the destruction of bacteria, viruses and algae in commercial pools and spas.
Characteristics
- Fast-dissolving granule
- Disinfecting action
- Algicide treatment
- Average chlorine equivalent content equal to 68 % on the date of manufacture
- Minimum chlorine equivalent content equal to 65 % on the date of manufacture
- Minimized insoluble production (less than or equal to 3 % on distilled water)
- Isocyanuric acid free (stabiliser)
- Suitable for use with all kinds of water, including very hard water
- Compatible with all types of filtrations
- No degassing in comparison to isocyanurates
Complies with the EN 900 standard
Dosage
1 kg for 100 m³ per day
USE BIOCIDAL PRODUCTS WITH CAUTION. BEFORE USING, READ THE LABEL AND THE INFORMATION ABOUT THE PRODUCT.
INSTRUCTIONS FOR PREPARING CHLORINE SOLUTIONS
If the concentrated chlorine solution is prepared manually, the following procedure must be strictly followed:
- Always use a clean preparation container that should only be used to prepare chlorine solutions.
- Calculate the amounts of water and calcium hypochlorite needed to achieve the desired chlorine concentration (see the table below).
- Add at least 90% of the required amount of water (see table below) to the container.
- Slowly add the required amount of calcium hypochlorite to the water while agitating the solution.
- Add the remainder of the required water to bring the total volume to the desired level.
- Continue agitating for at least 15 minutes to ensure that the product is completely dissolved.
COMMERCIAL POOLS AND SPAS
- Do not allow anyone to enter the pool if the concentration of available chlorine is above the national limits, or in the absence of this, 3 mg/l for swimming pools and 4 mg/l for spas.
- For perfectly balanced water, maintain alkalinity (T.A.C.) at a level between 60 and 120 mg/l.
- In an open-air pool, maintain stabiliser concentration between 25 and 50 mg/l.
- Check the chlorine level in pools regularly because UV rays can partially degrade the chlorine.
- Adjust the pH between 7.0 and 7.4.
- Check that the filter is in operation.
- Permanent chlorination:
- Check that the preparation tank and the pump do not contain any stabilised chlorine (trichloroisocyanuric acid or sodium dichloroisocyanuratee: check the labels).
- Prepare chlorine solutions following the dosing table and instructions.
- Adjust the injection to maintain a level of chlorine that meets local regulations. In the absence of regulatory obligations, it is recommended to maintain a level of active chlorine between 1 and 3 mg/l for a pool and between 2.5 and 4 mg/l for a spa.
- Shock chlorination when opening the pool and if the water is green/cloudy: Adjust the injection rate to reach a concentration of available chlorine equal to 10 mg/l.
N° UFI
UFI:7192-T2M8-3FFT-23DJ
Certification
BAuA Reg.-Nr: N-76449; BAG Reg.-Nr: CHZN4266; PCS 93338; Toelatingnummer: 7248N
Caution!
Never pour water onto this product as it may react violently if it enters into contact with small volumes of water.
Application of this product is only authorised in pools that are connected to a waste water treatment plant.
Store in a dry place away from direct sunlight in a well-ventilated area, at an average daily temperature that does not exceed 30°C.
The expiry date and the batch number appear on the packaging.
Decanting must be avoided.
Never pour unused product onto the ground, into bodies of water or into pipes (sinks, toilets…) or drains.
Dispose of unused product, its packaging and any other waste in compliance with local regulations.
Use the tool (scoop or similar) provided. Do not store the tool inside the packaging.
The treatment must be carried out in the absence of bathers for shock treatment and until the product is completely dissolved for direct application as maintenance treatment.
This product should never come into contact or be mixed with any other preparation, wherever this may be (bucket, feeder, skimmer, tank, etc.).
Mesures d’atténuation des risques
W przypadku uzdatniania szokowego zabieg należy przeprowadzać, kiedy żadne osoby nie kąpią się, aż do całkowitego rozpuszczenia produktu przeznaczonego do bezpośredniego stosowania w ramach zabiegów konserwacyjnych. Stosowanie tego produktu jest dozwolone tylko w basenach podłączonych do oczyszczalni ścieków.
Ingredients contributing to the classification of the product
calcium hypochlorite ;
Biocidal product:
Product-type 2: Disinfectants and algaecides not intended for direct application to humans or animals. PT2
Users: Professional
SG – Water soluble granules
Active substance:
